How to install Mk 2 RS and ST Scoop instructions:

by Daniel Spence March 13, 2022

Firstly, unclip the slam plate which is help on with four screws at the front which need removing.

After that remove the slam panel place the intake into the car. Now use the slam panel and test the position of the scoop as it will have a desired snug position that it will want to sit in.

Once you have found the correct position for the scoop you will need a drill or screwdriver to place a hole through the frame of the car and through the scoop so that it is held in place using the screws provided. This hole will never be seen again.

The alternative for when you have found the correct position for the scoop is to hold the scoop in place with two screws through the top of the slam plate.

Then simply put your slam plate back on over the top of your intake and enjoy the new air flow!